851. The C.G. of a right circular cone lies on its axis of symmetry at a height of
A. h/2
B. h/3
C. hI4
D. hI5

852. Centre of gravity of a thin hollow cone lies on the axis of symmmetry at a height of
A. one-half of the total height above base
B. one-third of the total height above base
C. one-fourth of the total height above base
D. none of these.

853. The Centre of gravity of a 10 x 15 x 5 cm T section from its bottom, is
A. 7.5 cm
B. 5.0 cm
C. 8.75 cm
D. 7.85 cm

854. A square hole is punched out of a circular lamina, the diagonal of the square being the radius of the circle. If r is the radius of the circle, the C.G. of the remainder from the corner of the square on the circumference will be
A. r(rc + 0.25)
B. r(iT – 0.5)Tr -I- 0.25
C. rqc_-. 0.25)
D. rift+ 0.25J

855. The minimum number of rivets for the connection of a rivet hole and the gusset plate, is
A.1
B.2
C.3
D.4

856. The weakest section of a diamond riveting, is the section which passes through
A. first row
B. second row
C. central raw
D. one rivet hole of end row.

857. If b is the width of a plate joined by diamond riveting of diameter d, the efficiency of the joint is given by
A. b + d
B. b – d
C. -E (1 – m)
D. P (1 + m)

858. The type of butt joints in common use, is :
A. single inverted V-butt joint
B. double V-butt joint
C. double U-butt joint
D. single V-butt joint.

859. The maximum load to which a fillet joint of length L can be subjected to, is
A. 0.7 x S x fillet size x L
B. 2 x S x fillet size x L
C. permissible shear stress x fillet size x L
D.S x fillet size x L 3

860. The maximum resistance against rotation, is offered by the weld at a point
A. most distant
B. least distant
C. at either end
D. centrally located.

NOTE
IF YOU THINK ANY OF THE MCQ ABOVE IS WRONG.
PLEASE COMMENT WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION IN COMMENT BOX.
THANK YOU